Our Location | Contact Us
about

Your position :home-CrushingOre Chute Feeder

  • Overview
  • Features
  • Technical parameters
  • Application
  • The chute feeder can be installed on the ground or onto discharge port of one bin. The chute bottom plates do the reciprocating movement. Stroke can be adjusted by the eccentric wheel; the eccentric throw is half of the stroke. According to experience of some mines sites, the eccentric throw should no less than 30mm for cohesive ore.
  • 1. Handy to operation.
    2. High efficiency and low cost.
    3. Best after-sale service. 
    The machines are used for ore separation, chemical, coal and other industrial segments. The machines run to feed the massive materials into the feeding equipment from materials warehouse (not applicable to powder-shape ore concentrates or materials of 500mm or above).
    Chute Feeder can be put on the ground, or lifting on the discharging opening of the ore storage bin is OK. The baseboard of the chute does reciprocating motion. The frequency of stroke of it is 20-60 times/min, the stroke is 20-200mm. The stroke is as two times as the eccentric throw; and it can be adjusted by the eccentric wheel of the driving device.
  •  

    Type

    Size of discharging openingmm

    Max discharge size (mm)

    Times of reciprocating(times/min)

    Feeding capacity(t/h)

    Motor power (KW)

    Dimension(mm)

    Weight(t)

    600×500

    600×500

    205

    38.9

    10.525.5

    4

    2750×910×855

    1.1

    980×1240

    980×1240

    350

    23.7

    3690

    7.5

    3560×1000×1070

    1.9

    1000×1900

    1000×1900

    300

    27

    300

    7.5

    3900×1590×1340

    2.6

  • The chute feeder is suitable for concentrating, coal, chemical and other industry department; the granular and piece materials are carried into different set from the storage bin, but not suitable for carrying the concentrate power and other power material. 
    According to the experience of some dressing plants, the eccentric arm is no less than 30mm for sticky ores. The groove body of Chute Feeder is about as wide 2-2.5 times as the max feeding size. The max type Chute Feeder can satisfy the feeding size of iron ore less than 500mm. The type 980*1240 Chute Feeder is the most commonly employed one. And the charging size of it is 350-0mm. It is suitable for the feeding to Jaw Crusher of 400*600.

Product center

Crushing

Grinding

Dressing

Sieving

Home | Ord Page | XmlChina Henan Heavy Industrial Factory Add:NO.239 road nanyang, Zhengzhou, China
Postcode:450001 T E L : +86-371-63712098